Panel mounting, Bracket mounting, Panel mounting -34 bracket mounting -34 – Simrad ROBERTSON AP45 User Manual
Page 84: 41 p, Anel mounting, 42 ri35 b, Racket mounting
Page 5-34
Robertson AP45 Autopilot
Installation
Simrad Robertson AS
Egersund - Norway
Panel mounting
•
Make a panel cut-out of 126 x 102 mm.
•
Use the supplied fastening device to
secure the unit to the panel. See Fig.
5-41
Fig. 5-41 Panel mounting
Bracket mounting
•
Mount two of the bracket halves to the RI35.
•
Temporarily bolt together the other two halves of the bracket to the
first two halves.
•
Hold the RI35 in place by hand and mark the 4 holes for the fixing
screws on the mounting surface.
•
Remove the RI35, drill the 4 mounting holes in the mounting surface.
•
Unbolt the temporarily fitted bracket halves and secure them to the
mounting surface using the self-tapping screws.
•
Assemble the complete bracket again and adjust the RI35 to best
viewing angle and tighten up the mounting bracket bolts.
Fig. 5-42 RI35 Bracket mounting