Smeg 142396 - Manual (Page 8)

142396
Required tools; socket spanner nr. 8,
screwdriver, torx 25
Caution! After unscrewing of before fi xing hinges,
hold the door to prevent it from falling and
damaging.
1. Remove upper hinge cover (keep it for eventual
later use), together with cover on the opposite
side of the upper hinge cover (on the opposite
side you will insert the attached cover during the
assembly), and remove the cover on the opposite
side of the upper part of the door.
2. Unscrew upper hinge screws and remove the
door from the bottom hinge.
3. On the bottom side of the door unscrew the
swing stopper screws and remove the stopper
(A) keep this stopper for later use. Fix the
attached stopper with its bearing on the opposite
side of the door.
4. Unscrew the forced door closure system (B)
and fi x it to the opposite side of the door (certain
models only).
5. Remove handle screw covers, unscrew handle
screws, and remove plastic pegs on the opposite
side.
6. Tilt the appliance backward (max. 35°) to lean
to the rear side of the cabinet. Unscrew the leg
support screws (C) - left and right, and remove
the leg support cover (D). Unscrew and remove,
then reciprocally replace the position of end
switch (E) and decorative peg (F) (for models
with forced door closing system). Place this on
opposite side. Unscrew three screws fi xing the
bottom hinge (keep the hinge for later use), and
fi x the attached bottom hinge on the opposite
side.
7. Proceed with the assembly procedure in opposite
sequence.
8
Reverse door swing