Sony LBT-ZUX9 - Manual (Page 44)

44 US
For Play Timer:
Press . or > repeatedly until the
audio source you want appears in the
display, then press ENTER. The
display will show the timer settings.
For Recording Timer:
The display will show the timer
settings. Load a recordable tape into
Deck B.
7
Press "/1 to turn off the system.
The system turns on 15 seconds before
the preset time.
Other operations
Notes
• If you use the Play Timer or Recording Timer
and the Sleep Timer at the same time, the
Sleep Timer has priority.
• The Play Timer and Recording Timer will not
be activated if the system is turned on or if
“STANDBY” flashes in the display.
• The volume is reduced to minimum during
Recording Timer.
Changing the display
1
Press AMP MENU repeatedly to
select the item you want.
The last selected setting for the item
appears in the display.
SPECTRUM
Turn on or off the spectrum analyzer
display.
SYSTEM DIMMER
Adjust the brightness of the display.
BEAM DIMMER
Adjust the brightness of the built-in
beam.
ILLUMINATION
Select the pattern of the power
illuminator when the X-ROUND mode
is not selected.
X-ROUND ILLUM
Turn on or off the power illuminator
when the X-ROUND mode is selected.
2
Turn OPERATION DIAL to select
the setting you want.
3
Press ENTER.
Notes
• When you turn MASTER VOLUME (or press
VOLUME +/– on the remote), the power
illuminator shows the current volume level.
• During the demonstration display, you can
turn on or off the power illuminator by
pressing BEAM MODE.
To Do this
Check the setting 1 Press CLOCK/TIMER
SELECT.
“SELECT” appears in
the display.
2 Press . or >
repeatedly to select
“PLAY SELECT?” or
“REC SELECT?”, then
press ENTER.
Change the
setting Start from step 1.
Cancel the Play
Timer or
Recording Timer 1 Press CLOCK/TIMER
SELECT.
“SELECT” appears in
the display.
2 Press . or >
repeatedly to select
“TIMER OFF?”, then
press ENTER.