Socket Mobile Ethernet Blaster Communications Cable - Manual (Page 11)

Chapter 1: About the EthernetBlaster Communications Cable 1–3
Introduction
© June 2008 Altera Corporation EthernetBlaster Communications Cable User Guide
The status LED on the target port side of the cable displays the operation status of the
EthernetBlaster communications cable. See
Table 1–1 for a description of each LED
status modes.
Static & Dynamic IP Addressing
The EthernetBlaster communications cable supports both static IP and dynamic IP
addressing, the latter by means of Dynamic Host Configuration Protocol (DHCP). By
default, the EthernetBlaster cable is configured at the factory to use dynamic IP
addressing. Upon power up, the cable attempts to obtain an IP address from your
network DHCP server. The Status LED is green and blinking while the network
address is being obtained and the cable is initializing. This process may take up to two
minutes.
When an IP address is obtained and the cable is ready to use, the status LED emits a
steady green light. If the attempt to obtain an IP address is unsuccessful (the DHCP
server may be down or absent), the cable switches to static IP addressing. The default
IP address is configured to 192.168.0.50. If static IP addressing is used, you must
configure your computer to an IP address in the same subnet as the cable to
communicate with it. The default setting requires your address to be in the 192.168.0.X
network domain.
Figure 1–1. EthernetBlaster Communications Cable Ethernet Port, Target Port, and Base Views
TARGET
STATUS
ETHERNET DC12V
Status LED
Target Port View Ethernet Port View
Base View
Ethernet Port 10-Pin Target Port
DC12V Jack
Machine Reset
Ethernet Blaster
Copyright 2004 Altera Corporation
00:07:ED:05:XX:XX
Host Name: acebXXXX
MAC Address
Host Name
Table 1–1. Status LED Modes
Status LED Status Description
Red-Green Power on, reset
Green, blinking Cable initialization
Green, steady Cable ready
Blue, blinking Downloading data to target printed circuit
board