Socket Mobile Ethernet Blaster Communications Cable - Manual (Page 33)

© June 2008 Altera Corporation EthernetBlaster Communications Cable User Guide
Info. Additional Information
Referenced Documents
For more information on configuration and in-system programmability (ISP), see the
following sources:
■ AN 39: IEEE 1149.1 (JTAG) Boundary-Scan Testing in Altera Devices
■ AN 95: In-System Programmability in MAX Devices
■ Configuring Cyclone FPGAs chapter in volume 1 of the Cyclone Device Handbook
■ Configuring Cyclone II Devices chapter in volume 1 of the Cyclone II Device Handbook
■ Configuring Stratix and Stratix GX Devices chapter in volume 2 of the Stratix Device
Handbook
■ In-System Programmability Guidelines for MAX II Devices chapter in volume 1 of the
MAX II Device Handbook
■ Serial Configuration Devices Data Sheet
■ Programming & Configuration chapter in the Introduction to Quartus II manual
■ The Programming module of the Quartus II online tutorial
■ Refer to the following glossary definitions in Quartus II Help:
■ “EthernetBlaster Cable” (general description)
■ “Configuration scheme” (general description)
■ “Programming files” (general description)
■ Refer to the following procedures in Quartus II Help:
■ Programming a Single Device or Multiple Devices in JTAG or Passive Serial
Mode
■ Programming a Single Device in Active Serial Programming Mode
■ Selecting the Communications Cable for the SignalTap II Logic Analyzer
■ Refer to the following introduction and overview topics in Quartus ® II Help:
■ Programmer Introduction
■ Overview: Working with Chain Description Files
■ Overview: Converting Programming Files