Sanyo POA-CH-EX06 - Manual (Page 8)

7
Installation Procedure
Adjustment
1
Adjust the forward/backward slide
(Adjustable range: 0 - 180 mm)
Loosen the four bolts on the top of the setting
¡
plate using a hexagon wrench (3 mm) and adjust
the slider of setting plate. After the adjustment,
tighten the four bolts which were loosened.
2
Adjust the vertical slide (Adjustable range: +4° - –2°)
Remove the left and right cover plates. ¡
Loosen the four bolts
¡ q
located inside the setting plate using a hexagon wrench (6 mm).
Adjust the vertical slide with the two bolts ¡ w
located inside the setting plate using a hexagon wrench (6
mm) (Adjust the left and right bolts so that their ends touch equally against the wall plate.)
Tighten the four bolts
¡ q
which were loosened using the hexagon wrench (6 mm).
After adjustment, attach the left and right cover plates again. ¡
3
Adjust the horizontal rotation (Adjustable range: +5° - –5°)
Loosen the two bolts ¡ q
located on the top of the setting plate using a hexagon wrench (3 mm).
Turn the adjustment knob
¡ w
located on the left side of the setting plate to adjust the horizontal rotation.
Tighten the two bolts ¡ q
which were loosened using the hexagon wrench (3 mm).
* “A” marks appear on the setting plate to indicate the locations of the bolts and adjustment knob.
Bolts
w
Bolts q
4°
2°
Bolts
0 - 7.09 inches
(0 - 180 mm)
Bolts q
Adjustment knob w 5° 5°