Sunfire OLE-2SF - Manual (Page 19)

Feature Enable/Disable:
Speaker
The Olé-SF contains a small
speaker that allows audible feed-
back signals to be heard as a result
of button pushes. This feature can
be disabled in the SunTools setup
software.
IR Sensor
The Olé-SF features a built-in IR
Sensor. IR signals from a hand-held
IR remote control pass through the
IR sensor and travel to the head-
end location where they control
IR sources located there. These
sources may be connected to a 3rd-
party Multi-Zone Controller or an IR
distribution network.
The IR Sensor can be disabled in
SunTools setup software.
Light Sensor Enable/Dis-
able
The Olé-SF touchpad has a light
sensor feature.
1. Install the unit in the wall, using
the wall plate that will be used in
the final installation.
. Adjust the room lighting to the
brightest setting possible.
3. Select a source on the touchpad.
The light sensor function only
works when the unit displays the
source icon screen.
4. Press and hold the "SELECT" but-
ton for five seconds. Depending
on the correct state of the sensor,
a message will be displayed:
“Release button to ENABLE
sensor”
or
"Release button to DISABLE
sensor"
Once the button is released, a
confirmation message will be sent:
Either:
"LIGHT SENSOR ENABLED"
or
"LIGHT SENSOR DISABLED"
When the Light Sensor is enabled,
the Olé-SF touchpad's backlight
will brighten or dim depend-
ing on the room's ambient light
conditions. When the sensor is
disabled, the Olé-SF remains at
full brightness no matter what the
ambient light conditions are like.
19