Samsung Tantus HLM 437W - Manual (Page 13)

Connecting a DVD Player
The rear panel jacks on your TV make it easy to connect a DVD player to your TV.
Connecting to Y,P b ,P r
1 Connect a set of audio
cables between the
Component1AUDIO IN
jacks on the TV and the
AUDIO OUT jacks on the
DVD player.
2 To enable Component video
viewing, connect video
cables between the
Component1 (Y, P
b and P r )
jacks on the TV and Y, P b
and P r (or Y, C b , C r ) output
jacks on the DVD player.
Note: For an explanation of
Component video, see your
DVD player's owner's man-
ual.
Connecting to audio and video jacks
1 Connect a set of audio
cables between the AUDIO
IN jacks on the TV and the
AUDIO OUT jacks on the
DVD player.
2 Connect video cables
between the VIDEO OUT
jack on the DVD player and
the VIDEO IN jack on the
TV.
25
Connecting a Camcorder
The side panel jacks on your TV make it easy to connect a camcorder to your TV.
You can use your camcorder to view tapes without using a VCR.
1 Locate the A/V output jacks
on the camcorder. They are
usually found on the side or
back of the camcorder.
2 Connect an audio cable
between the AUDIO OUT-
PUT jack on the camcorder
and the AUDIO terminals
on the side of the TV.
If your camcorder is stereo,
you must connect two sepa-
rate cables.
(The audio cables are usual-
ly included with the cam-
corder.)
3 Connect a video cable
between the VIDEO OUT-
PUT jack on the camcorder
and the VIDEO terminal on
the side of the TV. (A video
cable is usually included
with the camcorder.) To
watch a tape, follow your
camera’s instructions and
the section on “Viewing an
External Signal Source” in
this manual.
Connections
24