Samsung Tantus HLM 437W - Manual (Page 9)

Installing Batteries in the Remote Control
With normal use, the batteries in the remote control should last about a year. If you notice a performance
degradation while using the remote, the batteries may need to be replaced. Make sure you replace both
batteries and do not mix old and new batteries in the remote control. If you won’t be using the remote
control for a long time, remove the batteries and store them in a cool dry place.
1 Slide the back cover all the way out
to open the battery compartment of
the remote control.
2 Install two AAA size batteries.
Make sure to match the “+” and
“–” ends of the batteries with the
diagram inside the compartment.
3 Slide the cover back into place.
17
Remote Control
You can use the remote control up to a distance of about 23 feet from the TV. When using the remote,
always point it directly at the TV. The remote control can also operate your VCR, cable box, and DVD
player.
Your New Wide TV
16
1. POWER
Turns the TV on and off.
2. +100
Press to select cable channels over 100 on
TV.
3. Menu
Displays the main on-screen menu.
4. CH(Channel) and
VOL(Volume)
Controls volume, channel selection.
5. Mute
Press to mute the TV sound.
6. Display
Press to display information on the TV
screen.
7. Aspect
Press to change the screen size.
8. Surround
Press to hear the Dolby surround effect.
9. MTS(Multichannel
Television Stereo)
Press to choose stereo, mono or Separate
Audio Program (SAP broadcast).
10. Mode
Selects a target device to be controlled by
the Samsung remote control (i.e., TV, VCR,
Cable, or DVD).
11. Pre-ch
Tunes to the previous channel.
12. TV/Video
Press to display all of the available video
sources (i.e., TV, VCR, DVD, DTV, PC).
13. Joystick
Use to highlight on-screen menu items and
change menu values.
14. DNIe
Activates DNIe (Digital Natural Image
engine).
15. PIP
Activates picture in picture.
16. Still
Press to stop the action during a particular
scene. Press again to resume normal video.
17. Fav.CH (Favorite
Channel)
Press to switch between your favorite chan-
nels.
18. S.Mode
Adjust the TV sound by selecting one of the
preset factory settings (or select your per-
sonal, customized sound settings.)
19. P.Mode
Adjust the TV picture by selecting one of the
preset factory settings (or select your per-
sonal, customized picture settings.)
20. VCR controls
Controls VCR tape functions: Rewind, Play,
Fast Forward, Stop, Pause.
21. PIP controls
Source ; Press to select one of the available
signal sources for the PIP window.
Scan; Press to scan the memorized
channels.
Locate; Press to move the PIP window to
any of the four corners of the TV screen.
Swap; Exchanges the video signal that is
currently displayed on the main screen with
the signal in the PIP window.
Size; Press to make the PIP window larger
or smaller.
CH(PIP); Displays the available channels in
sequence. (These buttons change channels
in the PIP window only.)
22. V.chip
Press to set up and activate the parental
locks.
23. Set
Used during set up of this remote control,
so that it will work compatibly with other
devices (VCR, cable box, DVD, etc.)
24. Sleep
Press to select a preset time interval for
automatic shutoff.
25. Add/Erase
Press to add or erase channels in the TV’s
memory.
Use the Add/Erase button to
memorize/erase the fine tuning after fine
tuning channels.