Sony 3-300-703-11(2) - Manual (Page 14)

14 GB
C D-LIGHT SYNC OUT jack
Connect the D-LIGHT SYNC controller.
You need to connect the D-LIGHT SYNC
controller to a lighting device* (not
supplied). The lighting device will react
according to the control signals
transmitted by the D-LIGHT SYNC
controller upon receiving music source
from the system. For details on the use of
the D-LIGHT SYNC controller and
lighting device, refer to the operating
instructions supplied with the respective
device.
* Refer to the operating instructions supplied
with the D-LIGHT SYNC controller for the
recommended lighting device.
Note
The lighting effect may be different depending
on the connected lighting device or the type of
music being played back.
D SYSTEM CONTROL jack
Connect the system connector of
subwoofer to the SYSTEM CONTROL
jack on the unit.
Insert the plug of the SYSTEM
CONTROL cord into the jack, then secure
the screws of the plug.
E FRONT SPEAKER terminals
Connect the front speaker left/right to the
terminals on the subwoofer.
Insert only the stripped portion of the
speaker cords into the FRONT SPEAKER
terminals.
Note
Be sure to use only the supplied speakers.
F VOLTAGE SELECTOR
For models equipped with a voltage
selector on the subwoofer, set VOLTAGE
SELECTOR to the position of your local
power line voltage.
Depending on the model, the VOLTAGE
SELECTOR may differ.
G Power
Connect the power cord on the subwoofer
to a wall outlet after you have make all
connections. The demonstration appears
in the display. When you press "/1, the
system turns on and the demonstration
automatically ends.
If the supplied adaptor on the plug does
not fit your wall outlet, detach it from the
plug (only for models equipped with an
adaptor).
D-LIGHT SYNC
controller cord
Unit (Left panel)
Subwoofer (Rear panel)
Screws
Plug
SYSTEM CONTROL cord
FRONT SPEAKER
R
L
VOLTAGE SELECTOR
230-
240V
120V 220V