Sunrise Medical JOERNS B684DC - Manual (Page 10)

10
Mattress Side Stops
1. The mattress side stop is
designed to help keep
the mattress from
sliding laterally on the
mattress deck. This
option can be installed
in combination with the
assist devices. Please
read the important
warnings related to this
option and follow all of the instructions below
prior to use.
2. Install the mattress side stop according to the
supplied instructions (contact Sunrise Medical to
acquire instructions if necessary).
3. Replace the mattress and check that the mattress
fills the width between stops. Also, check that the
mattress will not compress to less than 2.0" in
height under the user’s load, especially when sitting
on or sliding over the stop.
Push Bar
1. The push bar is designed
to make it easier to move
the B684DC beds.
Remember that the B684DC
bed is not designed to be
used as a resident transport
device. Please read the
important warnings
related to this option and
follow all of the
instructions below prior
to use.
2. Install the push bar
according to the supplied instructions (contact
Sunrise Medical to acquire instructions if
necessary).
3. When using the push bar to move beds, take care
to push down and forward on the push bar handle.
Pushing up or attempting to use the push bar to
lift the bed to overcome thresholds may cause it
to disconnect from the bed, resulting in a loss of
control of the bed.
4. Extra care should be taken when moving the bed
on any slope. Moving the bed on a slope requires
two people, one at each end of the bed. Never
use the push bar to move a bed on a slope that
exceeds the ANSI and/or ADA requirements for
accessibility.
4-Inch Extension
1. The 4-inch extension is
designed to extend the bed
deck approximately four
inches. This allows the use of
an 84" mattress on an 80"
deck or an 80" mattress on a
76" deck. Please read the
important warnings related to
this option and follow all of
the instructions below prior
to use.
2. Install the 4" extension according to the supplied
instructions (contact Sunrise Medical to acquire
instructions if necessary).
3. Check to make sure that the increase in overall
length does not produce a hazard to safety or
accessibility in the room.
4. Place the new mattress against the mattress stop
and check that the mattress covers the entire
length of the deck.
Trapeze Adapter
1. The trapeze adapter is
designed to allow for the
attachment of a trapeze
system to the B684DC bed.
Please read the important
warnings related to this
option and follow all of the
instructions below prior to
use.
2. Install the trapeze adapter
according to the supplied
instructions (contact Sunrise Medical to acquire
instructions if necessary).
3. Install the trapeze assembly onto the trapeze
adapter according to the trapeze manufacturer's
instructions.