Sanyo HEC-DR7700C - Manual (Page 6)

10 9
HOW TO INSTALL THE STAND
Installation
screws
1 Remove the covers on the outer
sides of the arm rests.
Insert the flathead screwdriver into the
holes under the cover and pull toward
you. (4 places)
5 Put the cords of the remote control
and sensor controller in the cord
hook on the back of the body.
2 Secure the stand on the left-hand
side of the arm rest, using the
installation screws (3 screws).
3 Place the covers on the outer sides
of the arm rests.
Install the cover A on the left-hand side,
and cover B on the right-hand side.
6 Put the remote control on the
remote control stand (upper part).
Put the sensor controller on the
sensor controller stand (lower part).
Put the remote control on the remote
control stand in a tilted position as the
arrow shows, and then push it in the
direction of arrow .
7 Put the cords of the remote control
and the sensor controller in the
hooks of the sensor controller stand.
The post holder in the
lower part of the sensor
controller stand has
hooks on both sides.
Place the sensor
controller cord with
the stopper in the hook
closer to the arm rest.
Place the remote control
cord in the opposite
hook.
4 Uninstall the cord hook from the
right-hand side of the arm rest,
and install it on the left-hand side.
Remote control
Sensor controller
Remote control
stand
Sensor controller stand
Uninstall
Install
Thread the cord
Uninstall
Install
Installation
screws
Tools needed: Phillips (crosshead) screwdriver, flathead screwdriver ( screwdrivers are not included)
Installation on the right-hand side of the chair Installation on the left-hand side of the chair
1 Remove the cover of the right-hand
side of the arm rest.
Insert the flathead screwdriver into the
holes under the cover and pull toward
you. (4 places)
2 Secure the stand on the right-hand
side of the arm rest, using the
installation screws (3 screws).
3 Place the cover on the right-hand
side of the arm rest.
4 Put the remote control on the
remote control stand (upper part).
Put the sensor controller on the
sensor controller stand (lower part).
Put the remote control on the remote
control stand in a tilted position as the
arrow shows, and then push it in the
direction of arrow .
5 Put the cords of the remote control
and the sensor controller in the
hooks of the sensor controller stand.
The post holder in the lower part of the
sensor controller stand has hooks on both
sides. Place the sensor controller cord with
the stopper in the hook closer to the arm
rest. Place the remote control cord in the
opposite hook.
Tools needed: Phillips (crosshead) screwdriver, flathead screwdriver ( screwdrivers are not included)
Remote control
Sensor controller
Remote control
stand
Sensor controller stand
Sensor
controller
Remote control
Sensor controller stand
Remote control
Sensor controller
Sensor controller stand
Cover A
Cover A
Insert
Pull toward you.
Cover B
Remote control cord,
Sensor controller cord
Cord hook
Stopper
Arm rest
Hook
Post
Post holder