Samsung SWL-3000AP - Manual (Page 69)

65
③ Select the following order to change Wireless Channel.
Enter the proper channel number after the phrase “Enter new Channel {1-
14}:”. Then, press [ENTER :
↵
]. Channel index should be between 1 and
14(differs from country to country).
Notice : If you are operating two or more Access Points in the adjoining cells,
keep the appropriate channel distance to avoid the interference. We recommend
you to keep the distance of at least 4 channels in the adjoining cells.
④ Only if AP is used for DHCP Client, you set DHCP Client with “Enabled”. In
this case, there is no need to set ⑤, ⑥, ⑦ below. The default setting is
“Disabled”.
⑤ Select the following order to set IP Address.
Enter the proper IP address after “Enter new IP Address :”. Then, press
[ENTER :
↵
]. Consult your system administrator for setting the proper value
of IP Address.
CMD(t,p,h): 2
↵
Enter new Channel {1-14}: 11
↵
CMD(t,p,h): 4
↵
Enter new IP Address : 16.3.60.208
↵
CMD(t,p,h): 3
↵
Enter new DHCP Client {enable, disable}: disable
↵
Enter Current Channel
Enter DHCP Client
Setting Selection
Enter IP Address