Samsung SWL-3000AP - Manual (Page 7)

2. Installation
Choose the place with the consideration of power outlet and network
connection (RJ-45 Cable connection) to install the Access Point.
Plug in the power cord to the power outlet and the power adapter.
Plug in the DC output to “DC in”. Make sure that the “Power” LED is on. If the
“Power” LED is not on, please check the connections of the power cord.
Notice : Use the supplied power adapter(DC 5V, 2A) only to prevent the
permanent failure of AP.
Confirm that “Wireless” LED of AP blinks.
If not, confirm that Wireless LAN Card of AP is properly mounted in case for
3000AP and 3000AP(DA). For 3300AP and 3300AP(DA), contact where you
purchase the product. The card should be inserted or extracted when the power
is off, and we are not responsible for any product failure due to disassemble by
users.
Notice : Use the supplied Wireless LAN card(3.3V) only to prevent the
permanent failure of AP.
Attach UTP Ethernet cable to the RJ-45 Connector.
Make sure that the “Ethernet” LED is on. If the “Ethernet” LED is on, you can
use the existing network with the Access Point; otherwise check the UTP cable
connections.
Attach RS-232C serial cable to the Access Point and the PC.
The parameters of Access Point can be configured through the connection of
RS-232C serial cable to the PC(Refer to Chapter 17).
When AP Manager is used, you may skip the step .
Change settings of AP according to user’ s selection referring User’ s Guide.