Sceptre Technologies X32 - Manual (Page 37)

SCEPTRE X32 HDTV User Manual
- 37 -
www.SCEPTRE.com
Connecting a PC
1. Make sure the power of X32 LCD HDTV and your PC is turned off.
2. Obtain a 15-pin D-Sub VGA cable, connect to the VGA output of
your PC and the other end to the VGA port off the back of your X32
LCD HDTV.
3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and
the other end to the VGA Stereo Input port.
4. Turn on the power of the X32 LCD HDTV and your PC.
5. Use the remote control’s source button or the source button on the
right side of the TV to switch to VGA.
Please Note :
• For the best picture, please set your PC resolution to
1360x768 at 60 Hz. Please refer to the PC or graphic card’s
manual for further instructions on how to set your resolution
and refresh rate.
• Please refer to your PC manual for video output
requirements of the video card.