Sea & Sea RDX-550D - Manual (Page 15)

1
E-14
OPEN
LOCK
Convex part
Concave
part
Convex part
Concave part
2
Align the convex part of the
Port with the concave part of
the port mount ring, and fully
insert the port into the housing
CAUTION
Attaching and Detaching the Port
Release the port lock on the
RDX housing (front case) by
sliding it in the direction of
the arrow as shown in the
diagram, and rotate the port
mount ring toward OPEN (in a
counterclockwise direction)
until it stops
Before attaching the port, make sure there are no specks of dust, scratches,
or deformities on the O-ring and the O-ring contact surfaces.
Port lock
Slide
CAUTION

Only the optional ports designed for SEA&SEA RDX-series housings can
be attached to this product.

This product is delivered with a housing body cap attached to the port mount.
Make sure to remove the housing body cap when attaching the port.

The housing body cap has no watertight capability.

When attaching the port to the housing, always refer to the instruction
manual provided.
Attaching the port
In order to use this product underwater, the optional port for the camera
lens must be attached to this product.