Sea & Sea RDX-550D - Manual (Page 18)

E-17
Pop up the camera's built-in
flash. Align the camera tray
with the camera base inside the
front case, and slide the camera
forward into the front case

Make sure to pop up the built-in flash
of the camera before mounting the
camera in the housing. Once the
camera has been mounted, the flash
button of the camera cannot be used,
and the camera's built-in flash cannot
be popped up.

Make sure the camera tray is inserted
all the way into the camera base until
it stops.

Make sure that the camera tray is
properly placed and the knob is
locked.
Mounting the Camera in the Housing
6
Pull the power switch and
focus/zoom dial out

Make sure that the O-ring is properly fitted in the O-ring groove before
setting of the rear case.
8
Place the rear case on the front
case, and close the buckles
See:
“Opening and Closing the Housing” (P. E-13)
Align the lever of the housing's
power switch and the camera's
power switch
7

After the camera is mounted in the housing, make sure to check that all of
the housing's control parts work properly and the camera functions correctly.
CAUTION
5
Power switch
Lever