Sea & Sea RDX-550D - Manual (Page 23)

E-22
With the YS converter (option)
Connect the strobe with the YS converter (option) when the strobe is
triggered in conjunction with the camera.
Align the round mark (or the notch
on the tip) of the connecting cable
with the round mark (or the convex
part inside) of the strobe bulkhead,
and then push it straight in
Remove the connector cap from the YS converter connector
Make sure there are no scratches
or debris on the O-ring of the
connecting cable being connected
1
2
3

Carefully observe the instruction manual for the YS converter before use.

A Grip-stay L (option) is required when using the YS converter.

Do not connect the strobe and the YS converter connector with a sync cord
(option) because this will damage the YS converter connector.
CAUTION
Connecting cable
YS converter
connector
Connecting the Strobe