Samson MediaOne 3a - Manual (Page 14)

8
MediaOne Series Rear Control Panel
The MediaOne Series' rear control
panel is where you will make your
connections for the left side passive
monitor, input signals and AC power. The
following section details the rear panel
connections.
Powering the MediaOne Series
Since the MediaOne Series are active
monitors with on-board power
amplifiers, it is necessary to connect
the right side monitor to an AC power
supply. Make sure that the main Power
switch is set to the off position and
connect the supplied IEC power cable
into the AC inlet.
Things that go Hum!
When running power cables, be careful
not to run the AC power cords or AC
extension cords in parallel to your input
cables. This will help reduce any AC hum
that can be picked up. If your have to
cross an AC line with an audio line, try to
cross them at a 90 degree angle for the
least amount of induced hum.
1. Power switch – The POWER switch is
used to turn on the MediaOne Series’
active electronics. When set to the
on position, the front panel blue LED
illuminates, indicating the MediaOne
Series are powered up and ready for
operation.
2. AC Inlet - Connect the supplied IEC
power cable here.
3. Voltage switch - The slide switch is
used to select the operating voltage.
NOTE: Be sure that the switch is
set to the correct voltage for your
country.
1
2
3
Operating the MediaOne Series
1
2
3
MediaOne 4a and 5a
MediaOne 3a
ENGLISH