Sony Ericsson NWZ-A826K - Manual (Page 5)

NWZ-A826/A826K/A828/A828K/A829
5
SECTION 2
GENERAL
This section is extracted
from instruction manual.
Rear
 RESET button
Resets the player when you press the
RESET button with a small pin, etc.
 Accessory hole (type I)
Used to attach the supplied stand or
the optional accessories.
Using the supplied stand
You can stand up the player using the
supplied stand.
Notes
When standing the player with the
stand, be careful not to press down or
knock the player.
Stand up the player horizontally as
shown. Do not stand it up vertically.
Parts and Controls
Front
 BACK/HOME button * 1
Press to go up one list screen level, or
to return to the previous menu.
Press and hold the BACK/HOME
button to display the Home menu.
 Headphone jack
For connecting the headphones.
Insert the jack pin until it clicks into
place. If the headphones are
connected improperly, the sound
from the headphones may not sound
right.
 WM-PORT jack
Use this jack to connect the supplied
USB cable, or optional peripheral
devices, such as supported
accessories for the WM-PORT.
 5-way button * 2
Starts playback and enables
navigation of the player’s on-screen
menus.
 Display
The display may vary, depending on
functions.
 Bluetooth antenna (aerial)
 Bluetooth indicator
Indicates the status of the Bluetooth
function.
 VOL + * 2 /– button
Adjusts the volume.
 BLUETOOTH button
Press and hold to turn on or off the
Bluetooth function, and to establish
or to end Bluetooth connection.
 HOLD switch
You can protect the player against
accidental operation by using the
HOLD switch when carrying it. By
sliding the HOLD switch to the
direction of the arrow
, all
operation buttons are disabled. If you
slide the HOLD switch to the
opposite position, the HOLD
function is released.
 OPTION/PWR OFF button * 1
Displays the option menu.
If you press and hold the OPTION/
PWR OFF button, screen turns off
and the player enters standby mode.
If you press any button while the
player is in standby mode, the “Now
Playing” screen, etc., appears and the
player is ready for operation.
Furthermore, if you leave the player
in standby mode for about a day, the
player turns completely off
automatically. If you press any button
when the player is turned off, the
start up screen appears first, then the
“Now Playing” screen appears.
Note
The player consumes battery power
very slightly even when it is in standby
mode. Therefore, the player might
turn completely off in a short time,
depending on the power remaining in
the battery.
 Strap hole
Used to attach a strap (sold
separately). You can attach the
supplied stand and a strap at the same
time.
* 1 Functions marked with on the
player are activated if you press and hold
the corresponding buttons.
* 2 There are tactile dots. Use them to help
with button operations.