Samsung M55 - Manual (Page 79)

4-13 Chapter 4. Connecting to the Internet
Wireless Network Setup Using the Wireless LAN Setup Program
The procedures to connect to an access point using a wireless LAN configuration pro-
gram are described. Since the wireless LAN configuration program is included in the
system software media , the user has to install the program.
1. Insert the system software media into the CD drive and install the wireless LAN
configuration program (PROSet).
Select System Software Media > User Installation > Wireless LAN Driver
ReadMe
, click ReadMe and install according to the instructions.
2. Double-click on the wireless LAN program ( ) icon on the taskbar.
Alternatively, click Start > All Programs > Intel PROSet Wireless > Intel PROSet
Wireless
.
3. In Available Networks, click on Refresh.
4. Select the name of an access point to connect to from the available network list
and click on Connect.
If a network does not appear, click on Refresh.
5. Enter a WEP key and click the OK button.
6. The Done window appears, click OK.
When a wireless connection to an access point is established, the connection icon
(
) appears in front of the name of the connected profile.
The Wireless Security Settings window may differ depending on the security set-
tings of the AP.
Click the Advanced button to set up network authentication, data encryption, etc.
For more security setting information, ask your wireless network administrator.
Refer to setting up the advanced settings by clicking on the Advanced button.
Network authentication : The network authentication options include an Open
System and Shared Key. When selecting Open Systems, no authentication is
applied (however, encryption is supported). When selecting Shared Key, a WEP
key is used for authentication. The default setting is Open System.
Data encryption (WEP) : The IEEE 802.11 WEP (Wired Equivalent Privacy) stan-
dard defines two levels of encryption, a 64-bit key (this is sometimes represented
by 40bits) and a 128-bit key.
Key index : Select the current encryption key index used by the access point out of
1 to 4.
Using an encryption key : Click Use pass phrase to activate, and enter 5 (for 64-
bit) or 13 (for 128-bit) alphanumeric characters (represented by 0-9, a-z, or A-
Z).
N N N N o o o o tt tt e e e e