Siemens MCM 1902 - Manual (Page 16)

Color monitor MCM 1902
8 - English A26361-K527-Z100-2-5E19
Connecting the monitor
See your PC's operating manual for details of the ports on the system unit.
!
Please note the information provided in the " Safety " section in the chapter " Important
notes " at the beginning of this manual.
Do not cover the ventilation openings of the monitor.
If you are assembling monitors beside each other, there must be a minimum distance of
30 cm between monitors of the same constructional type, to avoid image distortion. With
different monitors, the distance must be increased, if necessary.
1
2
1 = Power connector 2 = D-SUB connector (15-pin)
Ê Be sure that the monitor and the system unit are switched off.
!
The system unit's power plug must be pulled out!
The data cable supplied has two 15-pin D-SUB connectors for connection to the monitor and to the
system unit.
!
CE conformance and optimum picture quality are guaranteed only if you use the data
cable supplied.
Ê Connect one of the connectors of the data cable to the D-SUB connector on the monitor (2)
and secure the connector by tightening the safety screws.
Ê Connect the other connector of the data cable to the active monitor port on the system unit and
secure the connector by tightening the safety screws.
i
If your system unit has two monitor ports ("onboard" screen controller and separate
graphics card), the monitor port for the separate graphics card is usually active.