Sharp LL-T1815 - Manual (Page 13)

13
English
Deutsc
h
Fran
ç
ais
Italiano
Espa
ñ
ol
English
Connecting the monitor and turning the monitor on and off
Connection of headphones
(commercially available)
Headphones (commercially available) can be
connected.
Notes:
- When the headphones are connected, no sound
can be heard from the monitor speakers.
Headphones
Connect the accessory audio cable
When the accessory audio cable is connected to
the audio output terminal of the computer, the
sound of the connected computer is output from
the display speakers. You can also use the
headphone jack of the display.
Audio cable
Audio input
terminal
To audio output terminal
Headphone
terminal
Connecting the monitor to a power
source
Power terminal
Power cord
AC outlet
2.Connect the analog and digital signal cables
(purchased separately) to the 2-input cable, then
connect to a computer.
- Paying attention to connector orientation, firmly
insert the signal cable into the PC, and then
tighten the screws at both sides.
Notes:
- When using a 2-input cable, set [INPUT-2] to [2
LINES]. (p. 21, 24)
- The monitor connected to the mini D-sub
connector of the 2-input cable may not be
automatically recognized and setup under Plug &
Play. Perform storage of setup information
manually. (p. 30)
Analog signal cable
Analog RGB
output terminal
Digital signal cable
( NL-C01E, purchased separately)
Digital RGB output terminal