Sharp LL-T1815 - Manual (Page 21)

21
English
Deutsc
h
Fran
ç
ais
Italiano
Espa
ñ
ol
English
Adjusting the screen display
(With analog connection)
COOL ..... Color tone bluer than standard
• ........... Color tone slightly bluer than standard
STD ........ Color tone standard setting
• ........... Color tone slightly redder than standard
WARM .... Color tone redder than standard
USER
R-CONTRAST ........ button for blue-green
button for red
G-CONTRAST ........ button for purple
button for green
B-CONTRAST ......... button for yellow
button for blue
GAMMA
Adjust so that dark and bright images are easy to
see. If the screen is dark and hard to see, increase
the numerical value. If it is bright and hard to see,
lower the numerical value. ( buttons)
MODE SELECT-1 Menu
MODE SELECT - 1
INFORMATION
OFF TIMER
INPUT-2
1LINE 2LINES
INPUT-1 ANALOG
1280 x 1024 V : 60Hz H : 64kHz
Notes:
- To choose a menu option:
button
- To go to the next menu: MENU button
INFORMATION
A model name (MODEL), a serial no. (S/N), and
usage time (USAGE TIME) of the display can be
checked.
After selecting [INFORMATION], press the
button (Checking done: MENU button)
OFF TIMER
Power is automatically shut off when the set time
elapses.
After selecting [OFF TIMER], press the button
and set [ON] / [OFF] by pressing the buttons.
If selecting [ON], press the
button and set the
shut-off time by pressing the buttons. (Be-
tween 1 and 23 hours may be set, by the
hour.)(Setting done: MENU button)
- When [ON] is selected, the remaining time is
displayed in the upper right of the screen during
the last 5 minutes before the shut-off. (The
remaining time is displayed for approx. 5
seconds, on each minute)
- To clear automatic shut-off temporarily, press the
power button between the display of remaining
time and the shut-off of power.
To subsequently turn the power off, press the
power button again. (When next turning on
power, power is again automatically shut off
when the set time elapses.)
INPUT-2
Set [1 LINE] when connecting digital or analog
signal cables to a DVI-I input terminal (INPUT-2) on
the display.
Set [2LINES] when connecting a 2-input cable.
( buttons)
- If the connections and settings are not correctly
set, the screen will not be correctly displayed.