Smeg PLA8743X - Manual (Page 12)

Rev 0.0
11
USER INSTRUCTIONS EN
2.2.2 Selecting a program
In this dishwasher model all programming operations can only be performed
with the door closed. With the door open, the symbols “--” appear on the
display (ref. 8 fi g. 2-03) and the program indicator lights (ref. 7 fi g. 2-03)
remain off.
Select the programs using the relative buttons (see P1, P2, P3, P4, P5 fi g. 2-
04). Press the button relative to the required program (see tab. 2-03a, 2-03b).
The relative indicator light shines to confi rm the operation and the estimated
cycle time in hours and minutes (“h.mm”) appears on the display (ref. 8 fi g.
2-03).
If required, press the relative buttons to select any complementary programs
(e.g.: “Half-load”, “Sani option”, “program delay”; see para 2.2.8 “Options”).
2.2.3 Starting a program
To start the dishwasher, simply press the start/pause button (ref. 5 fi g. 2-03)
for a few seconds until the “Time to end” message on the display starts fl ash-
ing and a beep is heard. From now on, the cycle time shown on the display
(ref. 8 fi g. 2-03) will decrease. This time, which is updated during the washing
cycle, is “indicative” given that it is affected by washing conditions such as the
quantity and type of dishes, the inlet water temperature, etc.. It is therefore
normal to see this time change during a program (increases or decreases in
minutes), especially when moving on from one phase to the next (e.g.: from
washing to rinsing).
Fig. 2-04