Sony CDP-CX571 - Manual (Page 14)

Playing CDs Getting Started
13
Playing CDs
4 Push the JOG dial or press PROGRAM.
5
To program other discs/tracks, do the following:
To program
Other discs
Other tracks on the same disc
Other tracks on other discs
6 Press · to start Program Play.
To cancel Program Play
Press CONTINUE.
The program remains even after Program Play ends
When you press ·, you can play the same program
again.
When you press PROGRAM during Continuous or
Shuffle Play
The program will be played after the current track.
The program remains until you erase them
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers.
Checking the programmed order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
“AL” appears instead of the track number.) After the
last step in the program, the display shows “End” and
returns to the original display.
Repeat Steps
2 and 4
3 and 4
2 to 4
The disc being
programmed
Playing order
The track being programmed
1 8 2 3 4 5 6 7
DISC TRACK
STEP
PROGRAM
20 1
1
Changing the programmed order
You can change your program before you start playing.
To
Erase a track or disc
Erase the last track or
disc in the program
Add tracks or discs to the
end of the program
Change the whole
program completely
Erasing the program stored in memory
1 Press PROGRAM in the stop mode.
2
Hold down CLEAR until ”All Clr” appears in the
display.
You need to
Press CHECK until the track or
disc you do not want appears in
the display, then press CLEAR
Press CLEAR. Each time you
press the button, the last track or
disc will be cleared.
Follow the programming
procedure
Hold down CLEAR until
“All Clr” appears in the display to
erase the whole program, then
create a new program following
the programming procedure