Sony SAT-A1 - Manual (Page 14)

14 Chapter 3: Connecting Your System
TV Only
TV With RF Connector Only Refer to the illustration below.
1
Connect the RG-6 cable from the satellite antenna’s LNB to the DSS
receiver’s SATELLITE IN jack.
Some TVs label this jack RF IN,
instead of VHF/UHF IN.
2
Connect the DSS receiver’s VHF(SAT)/UHF OUT jack to the TV’s
VHF/UHF IN jack.
Note
A VHF/UHF connection does not provide stereo sound. To receive stereo
sound, you must use an A/V connection (described on page 15).
3
Connect one end of the telephone line cord to the DSS receiver’s
TEL LINE jack. Connect the other end to your home’s modular
telephone outlet.
4
Connect one end of the AC power cord to the DSS receiver’s AC IN
jack. Connect the plug end to an AC outlet.
Optional Connections
Y If you have a cable input, cable box, or a terrestrial TV antenna,
connect it to the DSS receiver’s VHF/UHF IN jack.
Y To connect the DSS receiver to your audio system, use audio cables
to connect the DSS receiver to your audio receiver’s AUDIO IN
jacks.
VHF / UHF
Coaxial
Cable
TV
Satellite Receiver
Telephone
Line AC Cord RG-6 Cable
from LNB
CONTROL S
IN
OUT
L R
AUDIO VIDEO S VIDEO
CH 3
CH 4
VHF/UHF
VHF(SAT)/UHF
IN
OUT
TEL LINE
AC IN
WIDE BAND DATA
SATELLITE IN RF REMOTE
AUDIO 3
OUT
LOW SPEED DATA
(MONO)
AC OUT
L R
1 2 3 4