Tractor requirements and capabilities, 1 rops and seat belt, Rops and seat belt -4 – Servis-Rhino FR162 User Manual

Page 110: Operation, Opera t ion

Advertising
background image

OPERATION

FR240-FR162 01/11

Operation Section 4-4

© 2011 Alamo Group Inc.

OPERA

T

ION

mower with a tractor that does not meet the following requirements may cause tractor or mower damage and
be a potential danger to the operator and passersby.

Tractor Requirements and Capabilities

ASABE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.

Tractor Safety Devices .................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield

Tractor Horsepower -Minimum ........ FR240 80HP; FR162 80HP

Drawbar............................................ 14” length for 540 RPM unit; 16” or 20” length for 1000 RPM unit, if
mower is equipped with Pintle Hook (Optional Equipment) drawbar length must be modified (see 3.4
Drawbar), rated to carry weight of mower, safety chain attachment point

Drawbar Vertical Load Minimum Capacity..............FR240 2770 lbs., FR162 2770 lbs.

Hydraulics ........................................ Minimum of 1 hydraulic port (extra 3-spool valve required). Minimum
2 ports, 3 ports recommended if additional,3-spool control valve is not used.

Front End Weights............................ As needed to maintain 20% weight on front axle

Power Take Off ................................ 540 RPM 6-spline or 1000 RPM 21-spline, 1-3/8” diameter output
shaft depending on mower operating speed.

For other PTO & Drawbar Category Combinations see your Tractor specifications.

Drawbar

Category

Tractor

Horsepower

PTO

TYPE

Drawbar

Length

I

80

1-3/8”-21

16”

II

80

1-3/4”-20

20”

III

80

1-3/8”-6

14”

1.1 ROPS and Seat Belt

The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003

Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or
even death could result from falling off the tractor--particularly during a turnover
when the operator could be pinned under the ROPS.

(SG-7)

Advertising
This manual is related to the following products: