Servis-Rhino FR162 - Manual (Page 165)

MAINTENANCE
FR240-FR162 01/11 Maintenance Section 5-9
©2011 Alamo Group
MAINTENANCE
(Figure MntP-R-0014) Grease and install the sleeve
bearing in groove at the end of the sleeve (only on
one half shaft).
(Figure MntP-R-0015) Slide the shield tube
assembly over the shaft, so that the bearing holes
in the shield align with the shield bearing groove on
the yoke.
(Figure MntP-R-0016) Install two shield bearings
per half shaft by pushing one bearing in each
bearing hole. The shield bearings should be
installed in the direction of the shaft rotation relative
to the shields.
(Figure MntP-R-0017) Attach safety decal as
needed.