Samsung HMX-M20SN - Manual (Page 137)

133
USB
Message Icon Informs that... Action
Fail Printer
Connecting
Change 'USB
Connect'
-
A problem occured when
connecting the camcorder
via USB to a printer.
• Check the USB cable.
• Try the connection procedure again.
• Switch “USB connect” function to
“PictBridge.”
Fail USB Connecting
Change 'USB
Connect'
-
A problem occured when
connecting the camcorder
via USB to a PC.
• Check the USB cable.
• Try the connection procedure again.
• Switch “USB connect” function to “Mass
Storage.”
Ink Error -
There is a problem with the
ink cartridge. • Check the ink cartridge.
• Put a new ink cartridge in the printer.
Paper Error -
There is a problem with the
paper. • Check the paper in the printer. If there is no
paper, insert paper.
File Error -
There is a problem with the
file.
• Your camcorder does not support this file
format.
• Try another file recorded on your
camcorder.
Printer Error -
There is a problem with the
printer.
• Turn the printer’s power off and on.
• Contact the printer manufacturer’s service
center.
Print Error -
A problem occured during
printing. • Do not remove power source or eject
memory card during printing.
When there is dew condensation, put the camcorder aside for an hour or two before using it
• What is dew condensation?
Dew condensation occurs when you move a camcorder between locations that have
significant temperature difference. The dew condenses on the external or internal parts
of the camcorder, and on the reflection lens. When this happens, it may cause the
camcorder to malfunction or damage the camcorder when you turn the power on.
• Exactly when does the dew condensation occur?
When you move the camera to a location with a higher temperature than the previous
location, or when you move it to a hot area suddenly. Examples:
- You record outside in cold weather during -- the winter and then move the camera in
indoors.
- You record outside in hot weather after being indoors or inside a car where the A/C was
running.
• What can you do?
Turn the power off, detach the battery pack, and leave the camcorder in a dry area for 1 to 2
hours before using it.
WARNING INDICATORS AND MESSAGES