Doc - notice and load number statement, Notification to the telephone company – Spectrum Brands TELEMATRIX SP-400 User Manual

Page 6

Advertising
background image

DOC - NOTICE AND LOAD NUMBER STATEMENT

NOTICE: The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets
certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will
operate to the user's satisfaction.

''This product meets the applicable Industry Canada technical specifications.”

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications
company. The equipment must also be installed using an acceptable method of connection. In some cases, the company’s inside w iring as-
sociated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord). The
customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the
user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic
water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or
electrician, as appropriate.

''The Ringer Equivalence Number is an indication of the maximum number of terminals allowed to be connected to a telephone inter-
face. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the
Ringer Equivalence Numbers of all the devices does not exceed five.''


[The term “IC:” before the certification/registration number only signifies that the Industry Canada technical specifications were met.]

NOTIFICATION TO THE TELEPHONE COMPANY

Before you may connect your telephone you must notify the telephone company of particular line(s)to which such connections is to be made,

and provided to the telephone company the FCC registration number and ringer equivalence number of the registered protective circuitry. The

customer shall give notice to the telephone company upon final disconnection of such equipment or circuitry from the particular line(s).

Malfunction Of Telephone

In the event that your telephone fails to work properly during your ownership and use of it, you should disconnect it from the telephone line to

determine if it is your phone that is not working properly or if it is a problem in the telephone company's network. If the problem is with your

telephone you should discontinue its use until it is repaired.

Telephone Connection Requirements

Except for telephone company- provided ringers, all connections to the telephone network shall be made through standard telephone company

provided jacks, in such a manner as to allow for easy and immediate disconnection of the terminal equipment. Standard jacks shall be so ar-

ranged that if the plug connected thereto is withdrawn, no interference to the operation of the equipment at the customer's premises which re-

mains connected to the telephone net work shall occur by reason of such withdrawal. These telephones may not be used on party lines or coin

operated lines.

Changes In Telephone Company Equipment Or Facilities

The telephone company is entitled to make changes in its facilities equipment, operations, and procedures. Should these changes be expected

to render your terminal equipment incompatible with the telephone company's facilities you will be given sufficient notice to allow you to make

the necessary modification to your terminal equipment without any interruption of your service.

6

Advertising