Sony HD100 - Manual (Page 28)

28
Selecting an Antenna
You or your professional installer can choose to view information about
your Satellite Dish Antenna or your digital TV antenna. After you have
entered your antenna type, you can use the Antenna Location pop-up to
help aim your Satellite Dish Antenna or the Signal Strength Meter to help
aim your Satellite Dish Antenna or your digital TV antenna.
1 Highlight and select “Antenna” from the Antenna
display.
The Antenna Type display appears.
2 Highlight and select either “DIRECTV” or “Digital TV”
depending on which type of antenna you will check.
The DIRECTV Antenna Type display appears if you selected
“DIRECTV”.
The digital TV antenna information appears on the antenna
display if you selected “Digital TV”. You can then use the Signal
Strength Meter to help aim your digital TV antenna.
3 If you selected “DIRECTV” in step 2, highlight and select
the Satellite Dish Antenna type you have installed
The Signal Seeker pop-up appears on the Antenna display if you
selected “Round”. Skip to step 5 if you selected “Oval 2-Sat” or
“Oval 3-Sat”.
4 If you selected “Round” in step 3, highlight and select
“On”.
The Signal Seeker pop-up closes to show the DIRECTV Antenna
Type Display.
z Tip
Selecting “off” in the Signal Seeker
pop-up may allow you to see the Signal
Strength Meter if you use a diplexer or
certain other accessories with your
Satellite Dish Antenna.
Note
The Signal Seeker feature is available
only with the Sony Round Antenna.
See your Satellite Dish Antenna
Installation Instructions for more
information about this feature.
Setting Up Your Digital Satellite Receiver (SYSTEM)
(continued)