Siemens C62 - Manual (Page 10)

Getting started
9
C62 en SUG, A31008-H6880-A1-1-7619 (17. September 2003, 15:10)
©
Siem
ens A
G
2002
, L
:\C
62_S
quirrel_(m
c)\en\sug
\von_
itl\C62_
Startup.fm
Charging the battery
The battery is not supplied fully
charged. Plug the charger cable into
the bottom of the phone, plug the
power supply unit into the mains
power socket and charge for at least
3,5 hours.
Display when charging is in progress
h
During charging.
Charging time
An empty battery is fully charged af-
ter about 3,5 hours. Charging is only
possible within the temperature
range of +0 °C to +45 °C. If the tem-
perature rises/falls above/below this,
the charge symbol flashes a war-
ning. The voltage specified on the
power supply unit must not be ex-
ceeded.
To obtain maximum performance of
the battery it must be fully charged
and then emptied at least five times.
Charge icon not visible
If the battery was completely dis-
charged, the charging symbol will
not be immediately visible when
connected to the charger. In this
case the battery is fully charged after
4,5–5,5 hours.
Only use the charger provided!
Display while in service
Charge level display during opera-
tion (empty–full):
a d g
A beep sounds when the battery is
nearly empty. The charge level of the
battery is displayed correctly only af-
ter uninterrupted charging/discharg-
ing. You should therefore not remove
the battery unnecessarily and where
possible not interrupt charging prema-
turely.
Performance
A full battery will give you between
60–250 hours of standby time or
1,5–4,5 hours of talktime.
Note
The charger will become hot after extended
use. This is normal and not dangerous.