Stanton S.550 - Manual (Page 10)

9
OPERATIONS
10. Time display
Press TIME button to select time display mode:
TIME
TIME TIME
11. Matching the Beats Per Minute (BPM )
There are two tools available for matching the BPM of the two CDs:
c
Use the pitch slider to adjust the BPM satirically.
d Turn the JOG dial to change the BPM temporarily.
1) Pitch Slider
n To adjust the BPM by sliding the pitch slider up or down, press the PITCH button to turn on the PITCH adjustment
function before using.
o Slide the pitch slider up to decrease BPM, or down to increase BPM.
2) Turn the JOG dial
Turn the jog dial clockwise during play to increase the BMP in the forward direction, counterclockwise to decrease
the BMP in the reverse direction. The faster you turn the wheel, the more the BMP changes. The BMP changes with
a range of +/-16%.
When you release jog wheel, the CD will return to the tempo indicated by the pitch slider.
CD1 Bass beat
bass beat
CD2
bass beat
Bass beat
12. Program play
n Press the PROGRAM button, the player will enter the program mode and the CD will stop rotating.
o Select the desired track by pressing the SKIP button, then press the PROGRAM button again. The selected
track will be added to the program sequence.
p Repeat step 2 operation. A maximum of 20 tracks can be programmed at one time.
q Press the PLAY/PAUSE button to start the program play from the first selection.
r Press the program button again during program play to stop play.
s Press and hold the program button more than 2 seconds to cancel the program mode and erase all the current
program contents.
13. Loop Play
n Press the IN button to set the loop start point A, the LOOP indicator will flashes on the LCD.
o Press the OUT button to set the loop end point B, after the B point is set, the playback will enter the loop play from
A to B repeatedly.
p Press the RELOOP button, the loop play function is canceled, the LOOP indicator goes out.
14. Fader start
You have the possibility to start the respective CD-player directly from the mixer. Make sure that the Control socket is
connected with the respective socket on the mixer. Additionally, the Audio out socket have to be connected with the
Line-input sockets of your mixer. Please note that the Fader start function only works with the appropriate mixers.
Insert the CD and select the desired track. Start playback from your mixer.