Stanton S.550 - Manual (Page 11)

10
OPERATIONS
15. Relay-Play
In the Relay-operation, the device automatically switches to the other player after the current track is played.
In this way, you have the possibility to automate the play features between the two CDs. As soon as the current track
of CD1 is finished, the player automatically starts CD2. The first CD-player goes into Pause-mode. You can enter a
new CD or memorize a Cue-point at the respective player in the Pause-Mode.
To initiate single relay play:
Press the SGL (Single-button); The display shows “SINGLE” on both CD-players. Then press both PROG. & SGL
buttons simultaneously until the track indicator blinks (on both LCDs). Start playback of CD1. In the Single-mode, the
device automatically starts with the playback of the other CD-player of the other CD-player at the end of the track.
This can be changed to continuous by pressing the SGL (single) button once. In continuous mode the entire CD has
to play before the second player automatically starts.
***Note*** During the Relay-operation, the Faderstart function is disabled. CAUTION: The Relay-operation does not
work properly if the two CD-players are connected to different power amplifiers.
BEFORE SWITCHING OFF THE POWER
When you have finished using the CD player, before switching off the power, be sure that the disc holder had been closed
with the OPEN/CLOSE button.
CAUTION:
Do not forcibly close the disc holder when the power is off.
POWER OFF
8
POWER OFF
Do not switch off the power when the disc holder is open. Switch off the power after the disc holder has been
closed with the OPEN/CLOSE button.
COMPACT DISCS
1. Precautions on handling compact discs
y
Do not allow fingerprints, oil or dust to get on the
surface of the disc.
If the disc is dirty, wipe it off with a soft dry cloth.
y Do not use benzene, thinner, water, record spray,
electrostatic-proof chemicals, or silicone-treated
cloths to clean discs.
y Always handle discs carefully to prevent damaging
the surface; in particular when removing a disc from
its case or returning it.
y Do not bend the disc.
y Do not apply heat.
y Do not enlarge the hole in the center of the disc.
y Do not write on the label (printed side) with a hard-
tipped implement such as a pencil or ball point pen.
y Condensation will form if a disc is brought into a
warm area from a colder one, such as outdoors in
winter. Do not attempt to dry the disc with a hair dryer,
etc.
2. Precaution on storage
y
After playing a disc, always unload it from the
player.
y Always store the disc in the jewel case protect from
dirt or damage.
y Do not place discs in the following areas:
c Areas exposed to directs sunlight for a considerable
time.
d Areas subject to accumulation of dust or high
humidity.
e Areas affected by heat from indoor heaters, etc.