Siemens MOVIEMATE 50 - Manual (Page 4)

Open Communications Principles and Best Practices 19/03/2012, page 4
Preparation
This chapter contains all information that is necessary to connect an OpenStage phone to an
Asterisk based communication system.
This includes the power supply options (PoE or external supply) for each OpenStage model
and its possible sidecar combinations. To enable a secure environment, 802.1x support for
OpenStage is specified.
For autoconfiguration, LLDP-MED and DHCP can be used. In addition to the standard DHCP
options, SEN proprietary enhancements allow for assigning the address of a provisioning
service at phone startup for easy Plug & Play installation. By means of the provisioning
interface (WPI), mass deployment scenarios and remote administration during the phone’s
lifecycle are supported.
To facilitate configuration of a single phone by the administrator or user, OpenStage phones
feature a web interface in addition to the phone’s local interface.
Supplying Power for the Phones
The OpenStage phone family can be powered by
• External power supply
• Power over Ethernet (PoE)
Feature
OpenStage
15
OpenStage
20E
OpenStage
20
OpenStage
20 G
OpenStage
40
OpenStage
40 G
OpenStage
60
OpenStage
60 G
OpenStage
80
OpenStage
80 G
Legacy optiPoint
external Power
Supply (EU-, US- or
UK-plug)
Yes
(optional)
Yes
(optional)
Yes
(optional)
Yes
(optional)
Yes
(optional)
Yes
(optional)
Yes
(optional)
Yes
(optional)
Yes
(optional)
Yes
(optional)
New OpenStage
Power Supply (EU-,
US- or UK-plug) In line with the further development of our portfolio we are now able to offer
smaller and lighter power supplies for all OpenStage and optiPoint 410/ 420/
500 variants.
They feature a higher degree of efficiency leading to 14 - 19% lower power
consumption, depending on the connected devices.
Important: The new OpenStage power unit is a device of product category.
The protection concept of the power installation needs to achieve the
requirements of earth conductor (e.g. Schukostecker Typ F, country specific).
Power over Ethernet:
IEEE 802.3af
Yes Yes Yes Yes Yes
Power over Ethernet,
Cisco proprietary
mode
No No No No No
802.3af Power class OS 15: 1 OS 20E : 1
OS 20 : 1
OS 20 G: 2 OS 40: 2
OS 40 G: 3 OS 60 : 3
OS 60 G: 3 OS 80 : 3
OS 80 G: 3