Siemens MOVIEMATE 50 - Manual (Page 8)

Open Communications Principles and Best Practices 19/03/2012, page 8
parameters must be set or updated. When all these parameters have been sent to the phone,
it is ready for operation.
For further information, please refer to the WPI Developer’s Guide [8].
If a Firewall or NAT get in the Way
In case the phones and the provisioning service reside in different networks or subnets that
are separated by a firewall and/or NAT, it may be impossible for the provisioning service to
contact the phones.
To enable a solution for this problem, the phone can be configured to periodically poll
the provisioning service, or a special proxy, for new messages. Thus, provisioning service
driven interactions are possible even when the provisioning service is located behind a
firewall, or in a DMZ. For further information, please refer to the WPI Developer’s Guide [8],
Section 1.4.4.3, "Polling Request To Bridge A Firewall" and Section 3.1.2.2, "Provisioning
Service Located Behind A Firewall".
Single Phone Configuration (Local Menu, WBM)
Generally, it is recommended to administrate and configure an OpenStage phone installation
remotely using a provisioning service via the phone’s WPI (WorkPoint Interface). However,
there are two further configuration interfaces; these can be used to administrate individual
phones:
• Local menu: The user interface of the device itself.
• Web Based Management (WBM): The phone’s web interface.
Note: The default password for OpenStage administration is <123456>.
Local Menu
The phone’s application key ( ) is used to access the user and administration menu at the
phone.
Web Based Management (WBM)
The phone’s web interface can be accessed by any common web browser, like Firefox or
Internet Explorer. As HTTPS is used, the URL must be entered as follows:
https://<phone-ip-address>
If the browser displays a certificate notification, accept it.
Alternatively, the DNS name of the phone can be entered, if it has been configured and DNS
is available in the network.