Snom 220 - Manual (Page 22)

Basic Functions
22
Handset / Handsfree / Headset
The snom220 supports calls being made while using the handset or the
handsfree capability. During a call it is possible to switch between both
modes by pressing the function keys
/ or the Speaker key
on the right side beside the display.
If a headset is connected and the audio output is set to headset (“RJ
Conn” or “Chinch”), the snom220 will treat the headset as the output
device for calls. When the snom 220 is used in a call center environment
the connected headset will be the default setting for speaking on the
phone. The ENTER key
is therefore used to accept incoming calls.
Key mapping:
/ Switch to handsfree mode and back.
ENTER
Accept incoming calls in headset mode.
CANCEL
Returns the phone to the idle state.
Programmable Keys
The five keys to the right of the numbers block are the programmable
function keys that have the following options:
• Line
• Destination
• Intercom
• Park Orbit
• Voice Recorder
• DTMF (H323 only)
Each of these buttons has an LED indicating the status of the respective
programmable key at any given time.
Some features are common to all keys:
Pressing a key when its LED is blinking and the phone is ringing will
receive the call.
Pressing the key when a call is in progress at that key as indicated by
the constantly lighted LED, will put the call on hold.
Pressing a key while editing a number for dialing at that key will erase
the number and the phone will go to idle state.
Each of these different options will now be explained in detail.
Line
'Line' can be used in one of the following ways: