Sharp TL-M5200 - Manual (Page 42)

40
„ Setting the audio output type
(Audio Output)
This function determines whether the audio level
output from the audio output terminal is fi xed or
variable by linking with VOLUME.
Selectable
items
Description
FAO
(Fixed Audio
Output) Audio output that does not vary in
strength with the volume level of
the source monitor.
VAO
(Variable
Audio Output) Audio output that varies in strength
with the volume level of the source
monitor.
• When “Audio Output” is set to “VAO”, sound via speakers
is muted.
• When “Audio Output” has been set to “VAO”, fi rst make
sure to lower the volume of the monitor before turning the
power on or off and when switching the input.
• When the monitor is connected to audio equipment:
-- It is recommended that “FAO” be selected on “Audio
Output”. Because the audio signal from the audio
equipment does not vary in strength with the volume
level of the monitor, you can enjoy better sound.
-- When “FAO” is selected on “Audio Output”, video and
audio may not synchronize.
- When connecting audio equipment that has a function
for adjusting audio delay time, adjust the delay time
for synchronizing video and audio.
- When the audio equipment does not have such a
function and the unsynchronized video and audio
bothers you, select “VAO” on “Audio Output”.
Selecting “VAO” synchronizes video and audio
automatically.
Note
„ Setting the video system
(Video System)
The video input system mode is factory preset to
“Auto”; however, a clear picture from the connected
audio-visual equipment may not be received,
depending on the video signal difference. In that
case, switch the video signal.
Selectable
items
Description
Auto The video system is automatically
selected.
PAL When connected to PAL video
equipment.
SECAM When connected to SECAM
video equipment.
NTSC3.58 When connected to NTSC video
equipment.
NTSC4.43 When reproducing NTSC signals
in PAL video equipment.
PAL-60 When connected to 60 Hz PAL
video equipment.
• While “Video System” is set to “Auto”, when PAL-M or
PAL-N signal is input, the image from PAL signal will be
displayed.
Note
Menu operations