Samsung HT-TZ325 - Manual (Page 24)

24
connections
Do not insert any other card except the provided TX card. `
If a different TX card is used, the product may be damaged or the card may not be
removed easily.
Do not insert the TX card upside down or in the reverse direction.
`
Insert the TX card when the DVD Player is turned off. Inserting the card when it is turned `
on may cause a problem.
If the TX Card is inserted and wireless receiving module setting is complete, sound is not
`
output from the Rear Speaker connectors on the main unit.
The wireless receiving antenna is built into the wireless receiver module. Keep the unit
`
away from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver
`
module location is clear of any obstructions.
If no sound is heard from the wireless rear speakers, switch the mode to DVD 5.1
`
channel or Dolby ProLogic II .
In 2-CH mode, no sound will be heard from the wireless rear speakers.
`
M
Place the wireless receiver module at the rear of the listening position. If the wireless `
receiver module is too close to the main unit, some sound interruption may be heard due
to interference.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment,
`
or any other device that uses the same frequency (2.4GHz) near the system, some sound
interruption may be heard due to interference.
The transmission distance from the main unit to the wireless receiving module is about 33
`
feet (10m), but may vary depending on your operating environment. If a steel-concrete wall
or metallic wall is between the main unit and the wireless receiver module, the system may
not operate at all, because the radio wave cannot penetrate metal.
This product is also compatible with the wireless receiver module SWA-4000.
`
If the main unit doesn't make wireless connection, the system needs ID Setting between `
main unit and wireless receiver module.With the main unit turned off, press remote
control's number buttons "0""1""3""5" and main unit will turn on. With the wireless
receiver module turned on, press "ID SET" button on the back of the wireless module for 5
seconds.