Socket Mobile 6410-00233 - Manual (Page 12)

12
5. Your Pocket PC will begin searching for Bluetooth enabled devices in
range. After it finishes searching, select the CHS from the list of
discovered devices. The screen will vary depending on which Bluetooth
hardware you are using on your Pocket PC.
The Cordless Hand Scanner will appear as Socket CHS [xxxxxx], where
the characters in brackets are the last 6 characters of the scanner’s
Bluetooth MAC address. If multiple Cordless Hand Scanners were
detected, identify your unit by checking the MAC address printed on a
label underneath the batteries.
6. Your device will automatically connect to the CHS. If a passkey is
requested, enter 1234. To indicate the connection, the CHS will
beep once, and the SocketScan icon will change to show an image
of the scanner. If you are using the Socket SDIO or CF card, the Socket
Bluetooth icon in the task tray will also begin blinking.
Note: This screen
shows the CHS
discovered by Socket’s
SDIO or CF
Connection Kit. Your
screen may vary if you
are using different
Bluetooth hardware.
Note: If the host suspends or
the CHS is taken out of range,
the Bluetooth connection will
be lost. SocketScan (when the
host comes out of suspend
mode) will try to re-establish
the connection every 10
seconds for 30
seconds .