Scott WI-FI INTERNET/ETHERNET/FM PLL RADIO r x 400wl - Manual (Page 16)

TROUBLE SHOOTING GUIDE
Problems Recommendations
FM Radio
1. Noise or distorted 1.1
sound
Extend and position the FM antenna to achieve the best reception.
Internet Radio
2. Does not connect
to the Internet
2.1 Ensure that you have configured your home ne
connecting to the Internet from a PC using the sa
2.2 For a wired connection (Ethe
twork correctly by
me network.
rnet), check that the Ethernet cable is
r that you have
ed a static IP address. To configure the DHCP, you must
ccess point.
oes not restrict
unit MAC address
enus: “Settings”
tion”.
etwork, ensure that the correct WEP or
properly plugged in.
2.3 Ensure that a DHCP server is available o
configur
read the instructions supplied with the wireless a
2.4 Ensure that your wireless access point d
connections to particular MAC addresses. The
can be located by browsing through the m
Æ”System”Æ”Connection”Æ”Status”Æ”Configura
2.5 If you have an encrypted n
des ha WPA co ve been entered correctly.
3. The Internet
connection is
3.1 The s
3.2 The sta tati es not broadcast 24 hours per d
successful but
cannot play a
particular station listeners.
3.3 The station does not broadcast anymore.
3.4 The link on the unit is out of date.
3.5 The Internet connection between you and the server (often located
in a differ
on do ay.
tion has reached the maximum allowed number of on-line
ent country) is slow.
USB device, SD/MMC card
4. USB device 4.1 Insert it the other way round.
or SD/ MMC card
cannot be inserted
5. USB device or, 5.1 Some external hard disks m
SD/MMC card is
not read have a built-in power supply s
5.2 NTFS format is not supported . Check with the USB device file
system and format it with FAT or FAT32.
ay not be supported. Hard disks that
hould be favored.
5.3 Due to different technical specifications, some models of USB
devices, SD/MMC cards or MP3 players may not be read.
General
6. System hangs up
or abnormal
di
6.1 Press the ON/STANDBY ( ) button to go to Standby mode and
press it again to turn on the unit.
splay indication
6.2 Reset by unplugging the AC/DC adapter for few seconds and
plugging it back in.
7. No sound 7.1 Adjust the volume.
7.2 Disconnect the headphones.
8. The remote
control does not
work
8.1 Move closer to the unit and point toward the IR remote control
sensor.
8.2 Insert the battery with the polarity (+) matching the mark on the
bottom of the remote control.
8.3 Rep
8.4 The press an lace the battery.
d hold button operation works on the unit only.
Note: Should the problem persist, please download the
radio from http://www.awox.com/scott
firmware for this Internet
and place it
the AC/DC adapter and insert the USB device into
adapter back in and it will autom
on a USB device. Unplug
the unit. Plug the AC/DC
atically upgrade the system.
GB- 15