Scott WI-FI INTERNET/ETHERNET/FM PLL RADIO r x 400wl - Manual (Page 8)

BASIC OPERATIONS
ON/ STANDBY mode
After connecting the power supply (refer to previous section - CONNECTIONS),
press the ( ) ON/STANDBY button to turn on the unit or go to standby mode.
Navigation and number/character entry
Using the buttons on the unit
Turn the SCROLL/SELECT/SNOOZE knob to scroll through
the menu and press it to enter the highlighted item. You can
press the BACK button to return to previous menu. Press and
hold the BACK button to return to the main menu.
When
entering numbers, e.g. a time, turn the SCROLL/SELECT/SNOOZE knob to
adjust and press it to confirm. When entering characters, such
as a WEP/WPA key during the Wi-Fi connection set-up, turn
the SCROLL/SELECT/SNOOZE knob to adjust the number/
character and press it to confirm. Use the P2/
, P4/ buttons
to move to the previous or next number/ character. Press and
hold down the SCROLL/SELECT/SNOOZE knob (or press the
button) to
complete and confirm the entry.
Using the remote control
This is similar to using the unit except that you will need to use the UP
or
DOWN button to scroll through the menu and adjust the item. To complete
and confirm the entry, press the button as the “press and hold” button
operation does not work on the remote control.
In the main menu, you can choose: “FM Radio”, “Internet Radio”, “Media Server”,
“USB/SD/MMC”, “Aux In” and “Settings”.
“Settings” menu:
Settings Descriptions Display
Time Set the hour and minute of the clock time.
“disable”: Disable the alarm function.
“set /
enable”:
Set the alarm time and enable alarm
function.
Alarm
“select
source”:
Select the alarm source: “FM
preset”, “FM tune”, “Internet radio”,
“USB/ SD/MMC” or “buzzer”.
“Connection”
Set up the configuration to connect
the Wi-Fi or Ethernet,
or check the
connection status.
“Upgrade”: Upgrade the firmware via the Internet .
“Language”: Select the on-screen-display language.
System
“Reset”: Reset all settings to default values.
GB- 7