Sanitaire SC2800 - Manual (Page 9)

9
Automatic Shut-Off
NOTE: Always use the wet or dry vacuum cleaner in the upright position. If cleaner
tips over, the suction automatically shuts off.
If the cleaner tips over:
•
Turn off the power switch and set the cleaner upright.
•
Wait a few seconds for the motor to come to a complete stop.
•
Restart the motor.
When the tank is full:
•
As the tank fills with liquid, the ball float (inside the cage) rises until it seats itself
against the bottom of the motor.
•
The motor sound becomes a high pitch sound.
•
The shut-off stops the suction.
•
Turn off the power switch.
•
Empty the tank (instructions follow).
CAUTION: FOR LIQUID PICKUP WITH THE PLEATED FILTER IN PLACE, DO NOT
FILL ABOVE INLET OR SPILLAGE WILL OCCUR. Your filter repels liquids
and when installed prevents your vacʼs float mechanism from automatically
shutting off airflow. Airflow will cease when your filter is completely submerged
in liquid, but spillage will occur if the water level reaches the vac tankʼs inlet
before airflow stops. The liquid level at which airflow will cease will be higher
than the normal automatic shut-off level. Your vacʼs float mechanism resumes
operation after removing the filter. Your filter should be dried completely after
liquid pickup to avoid mildew growth.
Above-the-floor Cleaning Tools
•
Use reducer at hose end (see illustration on page 7).
•
Push desired tool onto the reducer.
•
Cleaning tools fit on hose end only.
HOW TO USE
(continued)
Empty Wet or Dry Contents from Tank
NOTE: Turn off the power switch and unplug electric cord to service.
•
If cleaning liquid, lift the hose and drain any liquid back into the tank. Then remove
the hose.
•
Empty contents into a suitable drain for liquids. Use a container for dry contents.
•
Use special care when emptying full tanks with liquids.
•
Replace lid and hose to continue cleaning.
Floor Nozzles
•
Push 1 1/2” diameter wand(s) onto hose end.
•
Push tool onto the wand end with locking nut. Tighten nut to secure tool. Do not
overtighten, tool should still swivel.