Sony 3-213-480-12(1) - Manual (Page 120)

120
COMPONENT VIDEO OUT (Y, P
B
/C
B
, P
R
/
C
R
)
Phono jack
Y: 1.0 Vp-p, P
B
/C
B
, P
R
/C
R
: 0.7 Vp-p, 75
ohms
S VIDEO OUT
4-pin, mini-DIN jack
Y: 1.0 Vp-p, unbalanced, sync negative
C: 0.3 Vp-p (PAL), load impedance
75 ohms
HDMI
HDMI 19 pin-Standard Connector
General
Power requirements
220-240 V AC, 50 Hz
Power consumption
33 W
Power back-up
Back-up duration: 0 min
Operating temperature
5°C to 35°C
Storage temperature
–20°C to 60°C
Operating humidity
25% to 80%
Dimensions including projecting parts
and controls (w/h/d)
Approx. 430 Ч 82 Ч 334 mm
Mass
Approx. 4.8 kg
Supplied accessories
Remote commander (remote) (1)
R6 (size AA) batteries (2)
Aerial cable (1)
Audio/video cord (1)
Design and specifications are subject to change
without notice.
Compatible colour systems
[DVD recorder section]
This recorder is designed to record using the PAL
colour system and play back using the PAL or
NTSC colour systems.
[VCR section]
This recorder is designed to record and play back
using the PAL colour system.
Recording of video sources based on other colour
systems cannot be guaranteed.
About i.LINK
The DV IN jack on this recorder is an i.LINK-
compliant DV IN jack. This section describes the
i.LINK standard and its features.
What is i.LINK?
i.LINK is a digital serial interface for handling
digital video, digital audio and other data in two
directions between equipment having the i.LINK
jack, and for controlling other equipment.
i.LINK-compatible pieces of equipment can be
connected by a single i.LINK cable. Possible
applications are operations and data transactions
with various digital AV equipment. When two or
more i.LINK-compatible equipment are
connected to this recorder in a daisy chain,
operations and data transactions are possible with
not only the equipment that this recorder is
connected to but also with other devices via the
directly connected equipment.
Note, however, that the method of operation
sometimes varies according to the characteristics
and specifications of the equipment to be
connected, and that operations and data
transactions are sometimes not possible on some
connected equipment.
Note
Normally, only one piece of equipment can be connected
to this recorder by the i.LINK cable (DV connecting
cable). When connecting this recorder to i.LINK-
compatible equipment having two or more i.LINK jacks
(DV jacks), see the instruction manual of the equipment
to be connected.
About the name “i.LINK”
i.LINK is a more familiar term for IEEE 1394 data
transport bus proposed by SONY, and is a
trademark approved by many corporations.
IEEE 1394 is an international standard
standardized by the Institute of Electrical and
Electronics Engineers.