Sanyo DTA-2680 - Manual (Page 19)

18
4.
Auto tuning - Press the TUNING forward or
backward buttons momentarily and release. The
tuner will move forward or backward to the next
available station.
Manual Tuning - Press and hold the SKIP forward/
backward buttons until the display approaches your
desired station. Then tap the buttons repeatedly
until the display shows the exact frequency.
Press the POWER/STANDBY button to turn the
system 'ON'. 1.
2. Press the TUNER/BAND button to select the
radio function.
3. Press the TUNER/BAND button repeatedly to
select AM or FM band.
1.
STORING PRESET STATIONS
The unit enables you to program 30 stations of FM
and 10 stations of AM band.
LISTENING TO THE RADIO
Example : FM mode
5. When finished listening, press the POWER button
to shut the system OFF.
Press the SKIP Forward or Backward buttons to
tune to the desired station.
2. Press the PROG button once, and the preset
station number will be flashing.
4. Press the PROG button again. The station is
stored.
Tune to the station you wish to store.
3. Press the PRESET button repeatedly to set the
desired preset station number.
5. To store other stations, repeat above steps.
RECALLING PRESET STATION
Press the PRESET buttons to select the
desired station.
FM
TUNER/
BAND
or
Note: For AM reception, plug the supplied frame
antenna into the AM ANT jack. Then adjust the frame
antenna until it is in position with the best reception.
Note: When setting or recalling the preset station by
directly pressing the number, on remote control unit
to press key number 0, 1 to preset station 01; press
0, 9 to preset station 09; press 1, 5 to preset station
15.