Sony Cyber-shot DSC-L1 - Manual (Page 16)

16
DSC-L1 2-186-445-13(1) [OpenType FONT]
Using the AC adaptor
1
DC plug
AC Adaptor
Jack cover
 Open the jack cover and
connect the AC Adaptor
(supplied) to the DC IN jack of
your camera.
Connect the DC plug with the  mark
facing up.
• Connect the AC Adaptor to an easily accessible
wall outlet (wall socket) close by. If any trouble
occurs while using the adaptor, immediately
shut off the power by disconnecting the plug
from the wall outlet (wall socket).
2
To a wall outlet
(wall socket)
Power cord
(mains lead)
 Connect the power cord
(mains lead) to the AC Adaptor
and then to a wall outlet (wall
socket).
• Do not use the AC Adaptor placed in a narrow
space, such as between a wall and furniture.
• After using the AC Adaptor, disconnect it both
from the DC IN jack of the camera and from a
wall outlet (wall socket).
• The set is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet (wall socket) even if the set itself
has been turned off.
Using your camera
abroad
Power sources
You can use your camera in any country
or region with the AC Adaptor/power cord
(mains lead) (supplied) within 100 V to
240 V AC, 50/60 Hz. Use a commercially
available AC plug adaptor
[a] , if necessary,
depending on the design of the wall outlet
(wall socket)
[b] .
AC-LS5/LS5B
• Do not use an electronic transformer (travel
converter), as this may cause a malfunction.