Sony RDR-GX257 - Manual (Page 15)

15
H
ook
up
s and
Se
tti
n
gs
b Notes
• Do not connect your TV’s audio output jacks to the
LINE 1 IN (AUDIO L/R) jacks at the same time. This
will cause unwanted noise to come from your TV’s
speakers.
• With connection B, do not connect the LINE 1 IN
(AUDIO L/R) and LINE OUT jacks to your TV’s audio
output jacks at the same time. This will cause unwanted
noise to come from your TV’s speakers.
• With connection A, after you have completed the
connection, make the appropriate settings in the
[Audio] setup (page 65). Otherwise, no sound or a loud
noise will come from your speakers.
• When you connect the recorder to an audio component
using an HDMI cord, you will need to do one of the
following:
– Connect the audio component to the TV with the
HDMI cord, or
– Connect the recorder to the TV with a component
video cord.
Step 4: Connecting the
Mains Lead (Power Cord)
Connect the supplied mains lead (the power cord)
to the AC IN terminal of the recorder. Then plug
the recorder and TV mains leads (AC power
cords) into the AC outlet. After you connect the
mains lead (the power cord), you must wait for
a short while before operating the
recorder. You can operate the recorder once the
front panel display lights up and the recorder
enters standby mode.
If you connect additional equipment to this
recorder (page 21), be sure to connect the mains
lead (the power cord) after all connections are
complete.
*1
*2
~ AC IN
to AC outlet
to AC IN 1
2