Sony RDR-GX257 - Manual (Page 81)

81
Addi
tion
al
I
n
fo
rm
at
io
n
The DV IN jack on this recorder is i.LINK-
compliant for digital video cameras.
i.LINK is a more familiar term for IEEE 1394 data
transport bus proposed by SONY, and is a
trademark approved by many corporations.
IEEE 1394 is an international standard
standardized by the Institute of Electrical and
Electronics Engineers.
For details on how to dub when this recorder is
connected to other video equipment having DV
jacks, see page 59.
The DV jack on this recorder can only input DVC-
SD signals. It cannot output signals. The DV jack
will not accept MICRO MV signals from
equipment such as a MICRO MV digital video
camera with an i.LINK jack.
For further precautions, see the notes on page 59.
For details on precautions when connecting this
recorder, also refer to the instruction manuals for
the equipment to be connected.
b Note
Normally, only one piece of equipment can be connected
to this recorder by the i.LINK cable (DV connecting
cable). When connecting this recorder to i.LINK-
compatible equipment having two or more i.LINK jacks
(DV jacks), refer to the instruction manual of the
equipment to be connected.
i.LINK and are trademarks.
Specifications
System
Laser: Semiconductor laser
Timer: Clock: Quartz locked/Timer
indication: 12-hour cycle (digital)
Video recording format: MPEG-2
Audio recording format/applicable bit
rate: Dolby Digital 2 ch
256 kbps (in HQ and SP mode), 192 kbps
(in LP and EP mode), 96 kbps (in ULP
mode)
Inputs and outputs
LINE 1 IN
(VIDEO): Phono jack /1.0 Vp-p
(AUDIO): Phono jack/2 Vrms/47 kilohms
LINE 2 IN
(VIDEO): Phono jack/1.0 Vp-p
(AUDIO): Phono jack/2 Vrms/more than
47 kilohms
LINE OUT
(VIDEO): Phono jack /1.0 Vp-p
(AUDIO): Phono jack/2 Vrms/600 ohms
AUDIO OUT: Phono jack/2 Vrms/600 ohms
DV IN: 4-pin/i.LINK S100
DIGITAL OUT (COAXIAL): Phono jack/
0.5 Vp-p/75 ohms
COMPONENT VIDEO OUT (Y, P
B
, P
R
):
Phono jack/Y: 1.0 Vp-p,
P
B
: 0.7 Vp-p, P
R
: 0.7 Vp-p
SET TOP BOX CONTROL: Mini jack
HDMI OUT: HDMI™ Connector
USB: USB jack Type A
General
Power requirements: 120 V AC, 60 Hz
Power consumption: 20 W
Dimensions (approx.):
430
Ч 53 Ч 258 mm (17 Ч 2
1 /
8
Ч 10
1 /
8
inch)
(width/height/depth) incl. projecting parts
Mass (approx.): 2.6 kg (5.73 lb)
Operating temperature: 5ºC to 35ºC (41ºF
to 95ºF)
Operating humidity: 25% to 80%
About i.LINK
,continued