Sony KDL-46X4500 - Manual (Page 45)

45 GB
Us
ing M
e
n
u
Fun
ctio
ns
Programme Labels Assigns a channel name of your choice, up to five letters or numbers. The name
appears briefly on the screen when you select the channel. (Names for channels are
usually taken automatically from Text (if available).)
1
Press F/f to select the channel you want to name, then press .
2
Press F/f to select the desired letter or number (“_” for a blank space), then
press g.
If you enter a wrong character
Press
G/g to select the wrong character. Then, press F/f to select the correct
character.
3
Repeat step 2 until you complete the name.
4
Press to exit the labeling procedure.
Manual Programme
Preset To preset a channel, press PROG +/– to select the programme number, before
selecting “Label”, “AFT”, “Audio Filter”, “Skip”, “Decoder”, or “LNA”. You
cannot select a programme number that is set to “Skip” (page 46).
Programme/
System/Channel Allows you to preset programme channels manually.
1
Press F/f to select “Programme”, then press .
2
Press F/f to select the programme number you want to
manually tune (if tuning a VCR, select channel 00), then
press RETURN.
3
Press F/f to select “System”, then press .
4
Press F/f to select one of the following TV broadcast
systems, then press RETURN.
B/G: For western European countries/areas
I: For the United Kingdom
D/K: For eastern European countries/areas
L: For France
5
Press F/f to select “Channel”, then press .
6
Press F/f to select “S” (for cable channels) or “C” (for
terrestrial channels), then press g.
7
Tune the channels as follows:
If you do not know the channel number
(frequency)
Press
F/f to search for the next available channel. The
search stops when a channel is found. To continue
searching, press
F/f.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of
the broadcast you want to tune, or the channel number of
your VCR.
8
Press to jump to “Confirm”, then press .
Your changes have been saved.
Repeat the above procedure to preset other channels
manually.
Label Assigns a name of your choice, up to five letters or numbers,
to the selected channel. This name appears briefly on the
screen when you select the channel.
To input characters, follow steps 2 to 4 in “Programme
Labels” (page 45).
AFT Allows you to fine-tune the selected channel manually if you
feel that a slight tuning adjustment may improve picture
quality.
You can adjust the fine tuning over a range of –15 to +15.
When “On” is selected, fine tuning adjustments are made
automatically.
(Continued)